Removal [05/2019 - ]: Procedure
- PRECAUTION WARNING:
Be sure to read Precoution thoroughly before serving.
Refer to PRECAUTION [05/2019 - ]
NOTE:After turning the engine switch off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Refer to PRECAUTION [05/2019 - ]
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL WARNING:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- If the airbag deploys for any reason. it may cause a serious accident.
- REMOVE AIR CLEANER CASE SUB-ASSEMBLY
Refer to REMOVAL [05/2019 - ]
- DRAIN BRAKE FLUID NOTE:
Wash off brake fluid immediately if it comes in contact with any painted surface.
- INSTALL BRAKE ACTUATOR WITH BRACKET
- Pull down the lock lever of the wire harness connector toward the front of the vehicle to release the lock.
- Disconnect the wire harness connector from the brake actuator assembly.NOTE:
Be careful not to allow brake fluid to enter the removed connector.
- Disconnect the clamp from the brake actuator assembly.
- Using a union nut wrench, disconnect the 6 brake lines from the brake actuator assembly.
- Use tags or make a memo to identify the places to reconnect.
HINT:
- *1: to front wheel cylinder RH
- *2: to front wheel cylinder LH
- *3: to rear wheel cylinder RH
- *4: to rear wheel cylinder LH
- *5: from front master cylinder
- *6: from rear master cylinder
- Disconnect the 3 clamps from the brake actuator bracket assembly.
- Remove the 3 nuts and brake actuator with bracket.NOTE:
Be careful not to damage the brake tubes.
- Pull down the lock lever of the wire harness connector toward the front of the vehicle to release the lock.