LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> LS 460L >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Automatic HVAC System) >> Refrigerant Lines >> Removal and Installation for Condenser >> Removal

Removal and Installation for Condenser: Removal

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Discharge the refrigerant. Refer to "HFC-134(A) (R-134A) SERVICE PROCEDURE ".
  2. Remove the radiator. Refer to "RADIATOR ".
    CAUTION: Be careful not to damage the core surface of the condenser and the radiator.
  3. Disconnect the high-pressure flexible hose and the high-pressure pipe from the condenser.
    CAUTION: Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.
  4. Disconnect the refrigerant pressure sensor connector.
  5. Remove the refrigerant pressure sensor.
    Fig 1: Identifying Refrigerant Pressure Sensor Condenser
    G00866914Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Carefully release retaining clips located on top driver side of condenser and rotate the condenser out of its mounts as shown.
    Fig 2: Rotating Condenser Out Its Mounts
    G00866915Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals