ENTRY LOCK AND UNLOCK SWITCH (for Front): Removal

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. REMOVE COWL TOP VENTILATOR LOUVER RH  (See REMOVAL )
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH  (See REMOVAL )
4. REMOVE FRONT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY LH  (See REMOVAL )
5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH  (See REMOVAL )
6. REMOVE FRONT DOOR SERVICE HOLE COVER LH  (See REMOVAL )
7. REMOVE FRONT INNER DOOR GLASS WEATHERSTRIP LH  (See REMOVAL )
8. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH  (See REMOVAL )
9. REMOVE FRONT DOOR OUTSIDE HANDLE COVER LH  (See REMOVAL )
10. REMOVE FRONT OUTSIDE DOOR HANDLE ASSEMBLY LH  (See REMOVAL )