Inspection Procedure

HINT:

Read freeze frame data using the hand-held tester or the OBD II scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, as well as other data from the time when a malfunction occurred.

1. Are there any other codes (besides DTC P2119) being output? 

   PREPARATION: 

   1. Connect the hand-held tester or the OBD II scan tool to the DLC3.
   2. Turn the ignition switch ON and push the hand-held tester or the OBD II scan tool main switch ON.
   3. When using hand-held tester, enter the following menu: DIAGNOSIS / ENHANCED OBD II / DTC INFO/CURRENT CODES.

   CHECK: 

   Read the DTC using the hand-held tester or the OBD II scan tool.

   RESULT: 

   DTC OUTPUT REFERENCE
   
   

   Display (DTC Output)	Proceed to
   P2119	A
   "P2119" and other DTC	B

   HINT:

   If any other codes besides P2119 are output, perform the troubleshooting for those DTCs first.

   1. B: Go to relevant DTC chart (See  DIAGNOSTIC TROUBLE CODE CHART   ). 
   2. A: Go To Next Step. 
2. Check if DTC outputs reoccur. 

   PREPARATION: 

   1. Clear the DTC (See PRE-CHECK ).
   2. Start and warm up the engine.
   3. Run the engine at idle for 15 seconds or more.
   4. Perform the stall test.

      Move the shift lever to D Position and fully depress the accelerator pedal for 5 seconds. Then release the pedal for 5 seconds or more.

   CHECK: 

   Read the DTC using the hand-held tester or the OBD II scan tool.

   OK: 

   1. No DTC output. 
   1. OK: System is normal. 
   2. NG: Replace throttle body.