Remove & Install or Remove & Replace
WARNING: This page is about the ES 300 Automatic, which is a different variant/trim than selected.
DOES NOT include alignment.
NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Both | 2.4 | B | ||
| Left Side | 1.2 | B | ||
| Right Side | 1.4 | B | ||
| Combination Procedure: AXLE SHAFT: Replace: NOTE: For Independent Suspension Type Axles, this operation consists of dissassembly and reassembly of the Axle Shaft Assembly and replacement of the Axle Shaft. | ||||
| Each | 1.0 | B | ||
| Combination Procedure: AXLE SHAFT BOOT: Remove & Replace: | ||||
| Inner &/or Outer,Each Side | 1.0 | B | ||
| Combination Procedure: AXLE SHAFT SUPPORT BEARING: Remove & Replace: | ||||
| 0.4 | B | |||
| Combination Procedure: CONSTANT VELOCITY JOINT: Remove & Replace: | ||||
| Each | 0.5 | B | ||
| Combination Procedure: TRANSAXLE OUTPUT SEAL: Remove & Replace: | ||||
| Each | 0.2 | B | ||