LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 1990 >> Range Rover Base >> Repair and Diagnosis >> Steering >> Power Steering >> Power Recirculating Ball >> Removal & Installation >> Power Steering Pump >> Removal

Power Steering Pump: Removal

  1. Disconnect the battery negative lead.
  2. Remove A.C. generator drive belt. See SPECIFICATIONS & DRIVE BELT ROUTING - 3.9L & 4.2L article in ENGINE COOLING.
  3. Remove water pump drive belt. See SPECIFICATIONS & DRIVE BELT ROUTING - 3.9L & 4.2L article in ENGINE COOLING.
  4. Remove left bank spark plug leads and detach distributor cap.
  5. Disconnect electrical plug from distributor amplifier unit.
  6. Loosen 2 nuts securing steering pump pivot bracket. See Fig 1 .
  7. Loosen 3 bolts securing pulley to steering pump. See Fig 1 .
  8. Loosen adjustment bolt and remove drive belt. See Fig 1 .
  9. Remove 3 bolts with plain washers and remove pulley. See Fig 1 .
  10. Disconnect fluid pipe from side of pump. See POWER STEERING FLUID PIPES  .
  11. Remove 3 bolts securing pump to pivot bracket. Remove pump as far as connected hose will permit.
  12. Remove hose from pump. See POWER STEERING FLUID PIPES  . See Fig 2 .
Fig 1: Removing Steering Pump Pulley
G00096811Courtesy of LAND ROVER NORTH AMERICA, INC.
Fig 2: Removing Steering Pump
G00096815Courtesy of LAND ROVER NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals