Repair Procedures: Replacement

WARNING: This page is about a different variant/trim than selected.

NOTE:

When removing with a flat-head screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Put on gloves to prevent hand injuries.
Take care not to bend or scratch the trim and panels.

Disconnect the negative (-) battery terminal.
(Refer to Engine Electrical System - "AUXILIARY BATTERY ")
Remove the inside rear view mirror cover (A)

Courtesy of KIA MOTORS AMERICA, INC.
Remove the multi sensor cover (A) by sliding the entire multi sensor cover to the bottom.

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the inside rear view mirror connector (A)

Courtesy of KIA MOTORS AMERICA, INC.
Remove the mounted screw and push the inside rear view mirror base upward to remove the inside rear view mirror assembly (A).

Courtesy of KIA MOTORS AMERICA, INC.
Install in the reverse order of removal.
Information
- Make sure the connector is connected properly.
- Be careful not to damage the windshield glass.