LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2019 >> Stinger GT2, RWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 3.3L >> Knock Sensor (KS) >> Repair Procedures >> Removal >> [Knock Sensor #2 (Bank 2)]

[Knock Sensor #2 (Bank 2)]

  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
  2. Remove the LH engine mounting support bracket.

    (Refer to Engine Mechanical System - " ENGINE MOUNTING  ") 

  3. Disconnect the knock sensor connector (A).
    G12803505Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the installation bolt (A), and then remove the protector.
    G12803506Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the installation bolt (A), and then remove the sensor from the cylinder block.
    G12803507Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals