LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2018 >> Forte S >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (Integrated Gateway Power Module Diagnosis) >> DTC B2211-00: CAN Time-Out BMS >> Wiring Inspection >> Circuit Inspection >> CAN Inspection

CAN Inspection

WARNING: This page is about a different car, the 2017 Kia Niro. However, it is still accessible from the selected car via links, so may be relevant.
CAN INSPECTION SPECIFICATION

CAN Inspection
Inspection Condition (+) Probe (-) Probe Specification
Connector Terminal Connector Terminal
  1. Ignition "ON".
 IGPM connector 2 (P-CAN High) Chassis ground - Figure below
IGPM connector 1 (P-CAN Low) Chassis ground -
Fig 1: Screen Display - Normal P-CAN Signal Waveform (Time Frame; 100)
G12328200Courtesy of KIA MOTORS AMERICA, INC.
Good 
  • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
  • Repair or replace as necessary and go to "VERIFICATION OF REPAIR " procedure.
No Good 
scientia non olet · About LEMON Manuals