Moisture Absorbent

WARNING: This page is about a different car, the 2017 Kia Niro. However, it is still accessible from the selected car via links, so may be relevant.

Turn the headlamp switch off.
Remove the dust caps (A) from the headlamp assembly after turning in the counterclockwise direction.
[LH]
1. Remove the diagnosis connector (A) after loosening the mounting screw.
  
  Fig 1: Removing Diagnosis Connector Mounting Screw
  Courtesy of KIA MOTORS AMERICA, INC.
2. Remove the dust cap (A).
  
  Fig 2: Removing Dust Cap
  Courtesy of KIA MOTORS AMERICA, INC.
  
  [RH]
  
  Fig 3: Locating Dust Cap (RH)
  Courtesy of KIA MOTORS AMERICA, INC.
Remove the moisture absorbent bracket (A) from the dust cover after loosening the mounting screws (B).

Fig 4: Removing Moisture Absorbent Bracket From Dust Cover
Courtesy of KIA MOTORS AMERICA, INC.
Remove the moisture absorbent (A) from the dust cap (B).

Fig 5: Removing Moisture Absorbent From Dust Cap
Courtesy of KIA MOTORS AMERICA, INC.
fold an new absorbent material as the picture below.

Fig 6: Locating Folding New Absorbent Material
Courtesy of KIA MOTORS AMERICA, INC.
Insert the moisture absorbent (A) with the folded sides up.

Fig 7: Inserting Moisture Absorbent With Folded Sides Up
Courtesy of KIA MOTORS AMERICA, INC.
Tighten the mounting screws (B), after installing the moisture absorbent bracket (A).

Fig 8: Locating Mounting Screws
Courtesy of KIA MOTORS AMERICA, INC.

Information

Be careful of the installation direction of the moisture absorbent bracket.

Fig 9: Locating Moisture Absorbent Bracket
Courtesy of KIA MOTORS AMERICA, INC.
Install the dust cap.