Inspect PCSV
- Ignition "OFF"
- Disconnect PCSV connector.
- Measure resistance between Pin No. 2 (Control) terminal and Pin No. 1 (Fuse-SENSOR2) terminal of the PCSV. (Component Side)
Specification: Approx. 18.5Ω to 22.5Ω at 20°C (68°F)
- Is the measured resistance within specifications?
YES
- Go to "INJECTOR INSPECTION " procedure.
NO
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the PCSV and go to "VERIFICATION OF REPAIR " procedure.