Universal Joint disassembly

WARNING: This page is about a different car, the 2011 Hyundai Veracruz. However, it is still accessible from the selected car via links, so may be relevant.

After marking alignment point on flange yoke and tube yoke, disassemble snap ring (B) on tube yoke.

Fig 1: Identifying Alignment Point
Courtesy of HYUNDAI MOTOR CO.
CAUTION:
- The alignment point assembles in the direction on marked reassemble.
- It is to minimize the change of balance.
Disassemble the case (A) by using hammer as shown below.

Fig 2: Identifying Case
Courtesy of HYUNDAI MOTOR CO.

Fig 3: Identifying Joint
Courtesy of HYUNDAI MOTOR CO.

CAUTION: Do not hit too strongly with hammer.
Disassemble snap ring (A) on the yoke.

Fig 4: Identifying Snap Ring
Courtesy of HYUNDAI MOTOR CO.
Disassemble the case (A) by using hammer as shown below.

Fig 5: Identifying Case
Courtesy of HYUNDAI MOTOR CO.

Fig 6: Inspecting Joint
Courtesy of HYUNDAI MOTOR CO.
CAUTION:
- Do not hit too strongly with hammer.
Installation is the reverse order of removal.