LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2013 >> Optima Hybrid EX >> Repair and Diagnosis (Single Page) >> Brakes >> Traction Control >> Antilock Brake System/Electronic Stability Control Diagnosis - HEV >> DTC C1513: Brake switch error >> Scantool diagnostics >> Monitor Scantool Data >> Monitor GDS Data

Monitor GDS Data

  1. Connect scantool to Data Link Connector(DLC)
  2. IG "ON".
  3. Press the brake pedal.
  4. Monitor the "Brake Light Switch" parameter on the GDS.
    Fig 1: Display - Current Data Of Brake Light Switch And Pressure Sensor
    G08314650Courtesy of KIA MOTORS AMERICA, INC.
  5. Whenever Brake pedal is pushed down, is the brake lamp switch's GDS data changed ON/OFF?

    YES 

    • Fault is intermittent caused by poor connection in brake light switch line and/or HECU's connector or was repaired and HECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals