Ground Circuit Inspection

Ignition "ON" & Engine "OFF".
Disconnect the "OUTPUT SPEED SENSOR" connector.
Measure resistance between terminal "1" of the OUTPUT SPEED SENSOR harness connector and chassis ground.
Specification: Approx. 0 Ω

Fig 1: Display Screen Of - Output Speed And Sensor Ground
Courtesy of KIA MOTORS AMERICA, INC.
Is resistance within specifications?
YES : --> Go to "COMPONENT INSPECTION " procedure.

NO : --> Check for open in harness. Repair as necessary and Go to "VERIFICATION OF VEHICLE REPAIR " procedure.

--> If ground circuit is OK, Go to 2 "Check PCM/TCM" of the "Component Inspection" procedure.