LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2020 >> Compass Limited, FWD >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel Injection, Diesel >> Sensor, Oxygen >> Removal And Installation >> Upstream 2.0L Diesel 170 CV >> Removal

Upstream 2.0L Diesel 170 CV: Removal

WARNING:

The exhaust manifold, exhaust pipes and catalytic converter(s) become very hot during engine operation. Allow engine to cool before removing oxygen sensor. Failure to allow engine to cool before removal may result in personal injury caused by burns.

CAUTION:

When disconnecting sensor electrical connector, do not pull directly on wires going into oxygen sensor (O2S). Damage to the oxygen sensor may occur.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the engine cover. .
    GC0163355Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the upstream oxygen sensor wire harness connector (1).
    GC0165339Courtesy of CHRYSLER GROUP, LLC
  4. Open the wiring harness retainer clip and release the wire harness then remove the upstream oxygen sensor (1).