Injector - Fuel: Removal

The fuel rail must be removed to gain access to the fuel injectors.

1. Disconnect injector wiring connector from each injector.
   Fig 1: Fuel Injector & Rail Typical

   Courtesy of CHRYSLER LLC

   1 - FUEL RAIL ASSEMBLY

   2 - FUEL INJECTOR

   3 - FUEL RAIL RECEIVER

2. Rotate injector (2) and pull out of fuel rail. The clip will stay on injector.
3. Check injector O-ring for damage. If O-ring is damaged, it must be replaced. If injector is reused, a protective cap must be installed on injector tip to prevent damage. Replace injector clip if it is damaged.
4. Repeat procedures for remaining injectors.