LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Liberty Renegade, 4WD, Part Time, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel Delivery - 2.8L Diesel >> Fuel Heater >> Installation

Fuel Heater: Installation

  1. Install fuel filter/water separator assembly. Tighten retaining fasteners to 24.5 N.m (18 ft.lbs.). See Figure.
    NOTE: Care must be taken when installing the fuel lines to assure proper routing. The lines can easily be crossed and cause a no start condition after the repair.
  2. Connect the fuel supply and return lines. Tighten clamps to 2.7N.m (24 in.lbs.). See Figure.
  3. Connect fuel heater, WIF and fuel temperature sensor electrical connectors.
  4. Prime fuel system using the fuel priming plunger. See Figure. (Refer to STANDARD PROCEDURE ).
  5. Connect negative battery cable.
scientia non olet · About LEMON Manuals