LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1992 >> Cherokee Briarwood, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> No-Start Tests >> Test NS-12C - Inspecting AIS Motor Operation

Test NS-12C - Inspecting AIS Motor Operation

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For wiring diagram, see WIRING DIAGRAMS  at end of article.

Turn ignition off. Disconnect and inspect engine controller 60-pin connector. Repair connector as necessary. Perform VERIFICATION TEST VER-1  . If connector is okay, check resistance of Brown/White wire (Red/Yellow wire on Wrangler) between AIS motor connector and engine controller connector terminal No. 40 using a DVOM. If resistance is less than 10 ohms, replace engine controller. Perform VERIFICATION TEST VER-1  . If resistance is 10 ohms or more, repair open Brown/White wire (Red/Yellow wire on Wrangler). Perform VERIFICATION TEST VER-1  .

scientia non olet · About LEMON Manuals