Trouble Code Determination (Hard Or Intermittent)

During any diagnostic procedure, you must decide between "hard failure" and "intermittent failure" codes. Diagnostic charts will not usually help analyze "intermittent failure" codes. To determine "hard failure" codes and "intermittent failure" codes, proceed as follows:

1. Enter diagnostic mode. Read and record all stored trouble codes. Exit diagnostic mode and clear trouble codes.
2. Apply parking brake and place transmission in Neutral (man. trans.) or "P" (auto. trans.). Block drive wheels and start engine. "CHECK ENGINE" lamp should go out. Run warm engine at specified curb idle for 2 minutes and note "CHECK ENGINE" lamp.
3. If "CHECK ENGINE" lamp comes on, enter diagnostic mode. Read and record trouble codes. This will reveal "hard failure" codes. Codes "13", "14", "15", "34", "44", "45" and "55" may require a road test to reset "hard failure" after trouble codes were cleared.
   NOTE: Any time codes "51", "54" or "55" are displayed with another code, start with "50-series" code first, then proceed to lowest numbered code.
4. If "CHECK ENGINE" lamp does not come on, all stored trouble codes were "intermittent failures". Exceptions are noted under Diagnostic Procedure.