LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2003 >> XJR >> Repair and Diagnosis >> Body & Frame >> Seats >> Seating >> Removal and Installation >> Rear Seat Track >> Installation

Rear Seat Track: Installation

  1. Position seat in vehicle and fit but do not tighten four bolts securing frame to floor.
  2. Fit and fully tighten the two bolts securing squab frame to rear panel.
  3. Fully tighten bolts securing frame to floor.
  4. Connect seat motor and squab heater harness multiplugs.
  5. Position side trim panel and carefully pass seat belt lower anchor through escutcheon and trim aperture.
  6. Fit and tighten seat belt anchor securing bolt.
  7. Position side trim and push downwards to engage keyhole on squab outer fixing.
  8. Position trim lower end over stud and fit and fully seat new scrivet.
  9. Position seat cushion for access and connect cushion heater harness multiplug.
  10. Push seat cushion rearwards to engage it in rear securing lugs.
  11. Fit and tighten cushion front securing bolts and nuts.
  12. Connect ground cable to battery terminal and fit battery cover. Refer to BATTERY CONNECT .
  13. Return seat to original position.
scientia non olet · About LEMON Manuals