LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2008 >> i-290 Standard >> Repair and Diagnosis (Single Page) >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition Lock Cylinder Case Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Ignition Switch & Lock Housing Assembly
    GM1492304Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition lock cylinder case.
    2. NOTE: Refer to Fastener Notice .
  2. Install the ignition lock cylinder case bolt and tighten it until the head shears off.
  3. Install the multifunction turn signal switch. Refer to Multifunction Turn Signal Switch Housing Replacement .
  4. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  5. The passlock sensor is part of the ignition switch. If replacing the ignition switch, a passlock relearn will be needed. Refer to Control Module References .
scientia non olet · About LEMON Manuals