Camber Adjustment

The camber angle can be adjusted by means of the camber shims (2) installed in position between the chassis frame (1) and fulcrum pins

CAUTION: Left and right side must be equal within 30'.

Fig 1: Adjusting Camber Angle (1 Of 2)

Courtesy of ISUZU MOTOR CO.

Fig 2: Adjusting Camber Angle (2 Of 2)

Courtesy of ISUZU MOTOR CO.

NOTE: Overall thickness of caster shim and camber shim should be 10.8 mm (0.425 in) or less.

Tighten the fulcrum pin bolt to the specified torque.

Torque: 152 N.m (112 lb ft)

Fig 3: Angle Change Chart

Courtesy of ISUZU MOTOR CO.