Confirmation Procedure

PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
NOTE:
Before performing the following procedure, check that battery voltage as the following.
- Ignition switch ON: More than 11 V
- Engine cranking: More than 7 V
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Shift the selector lever in N range.
3. Start the engine and let it idle at least 5 seconds.
4. Check DTC.
Is DTC P0365 detected?

YES

Refer to DTC Diagnosis Procedure .

NO

To check malfunction symptom before repair: Refer to Inspection .

NO

Confirmation after repair: INSPECTION END