VR30DDTT engine

1. Turn ignition switch OFF.
2. Disconnect CMP sensor (bank 2) harness connector.
3. Turn ignition switch ON.
4. Check the voltage between intake CMP sensor (bank 2) harness connector and ground.

   +		-	Voltage (Approx.)
   Intake CMP sensor (bank 2)
   Connector	Terminal
   F97	1	Ground	5 V

Is the inspection result normal?

YES

GO TO 3.

NO

GO TO 2.

1. Turn ignition switch OFF
2. Disconnect ECM harness connector.
3. Check the continuity between intake CMP sensor (bank 2) harness connector and ECM harness connector.

   Intake CMP sensor (bank 2)		ECM		Continuity
   Connector	Terminal	Connector	Terminal
   F97	1	F143	60	Existed

4. Also check harness for short to ground and short to power.

Is the inspection result normal?

YES

Perform the trouble diagnosis for ECM power supply circuit.

NO

Repair or replace error-detected parts.

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check the continuity between intake CMP sensor (bank 2) harness connector and ECM harness connector.

   Intake CMP sensor (bank 2)		ECM		Continuity
   Connector	Terminal	Connector	Terminal
   F97	2	F143	76	Existed

4. Also check harness for short to power.

Is the inspection result normal?

YES

GO TO 4.

NO

Repair or replace error-detected parts.

1. Check the continuity between intake CMP sensor (bank 2) harness connector and ECM harness connector.

   Intake CMP sensor (bank 2)		ECM		Continuity
   Connector	Terminal	Connector	Terminal
   F97	3	F143	67	Existed

2. Also check harness for short to ground and short to power.

Is the inspection result normal?

YES

GO TO 5.

NO

Repair or replace error-detected parts.

Check intake CMP sensor (bank 2). Refer to Component Inspection .

Is the inspection result normal?

YES

GO TO 6.

NO

Replace intake CMP sensor (bank 2). Refer to CAMSHAFT : Exploded View .

Check the following items:

• Accumulation of debris to the signal plate intake camshaft (bank 2) rear end

  Courtesy of NISSAN NORTH AMERICA, INC.

• Chipping signal plate of camshaft rear end

Is the inspection result normal?

YES

INSPECTION END

NO

Remove debris and clean the signal plate of the camshaft rear end or replace the camshaft. Refer to CAMSHAFT : Exploded View .