DTC Confirmation Procedure

If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

: GO TO 2.

With CONSULT 

1. Start the engine.
2. Select "ATF TEMP 1" in "Data Monitor" in "TRANSMISSION".
3. Check ATF temperature is in the following range:

   ATF TEMP 1: 20°C (68°F) - 140°C (284°F)

With GST 

1. Start the engine.
2. Drive vehicle for approximately 5 minutes in urban areas.

   Is ATF temperature within specified range? 

   YES: GO TO 3.

   NO: Drive vehicle to warm ATF or stop engine to cool ATF.

With CONSULT 

1. Select "4TH GR FNCTN P0734" in "DTC & SRT confirmation" in "TRANSMISSION".
2. Drive vehicle with manual mode and maintain the following conditions:

   GEAR: 4th

   ACCELE POSI: 0.7/8 or more

   VEHICLE SPEED: 10 km/h (7 MPH) or more

3. Keep the current driving status for 2 seconds or more if CONSULT screen changes from "OUT OF CONDITION" to "TESTING".
   CAUTION: When "TESTING" is not indicated on CONSULT for a long time, check "Self Diagnostic Results" in "TRANSMISSION". When a DTC other than "P0734" is detected, check the DTC. Refer to "DTC INDEX ".

With GST 

1. Drive vehicle and maintain the following conditions for 2 seconds or more:

   Selector lever: "M" position

   Gear position: 4th

   Accelerator pedal opening: 0.7/8 or more

   Vehicle speed: 10 km/h (7 MPH) or more

2. Check DTC.

   Is "OUT OF CONDITION", "STOP VEHICLE" or "COMPLETED RESULT NG" displayed? / Is "P0734" detected? 

   YES-1 (OUT OF CONDITION): Perform "Step 3" again.

   YES-2 (STOP VEHICLE): GO TO 4.

   YES-3 (COMPLETED RESULT NG): Go to "DIAGNOSIS PROCEDURE ".

   YES-4 ("P0734" is detected): Go to "DIAGNOSIS PROCEDURE ".

   NO: GO TO 4.

1. Stop vehicle.
2. Drive vehicle in "D" position allowing it to shift from 1GR to 7GR and check shift timing and shift shock.

   : INSPECTION END