DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.

CHECK DTC DETECTION
With CONSULT-III
1. Start the engine.
2. Select "Data Monitor" in "TRANSMISSION".
3. Drive vehicle and maintain the following conditions for at least 10 minutes (total). (It is not necessary to maintain continuously.)
  VHCL/S SE-A/T : 10 km/h (6 MPH) or more
  
  ACCELE POSI : More than 1.0/8
  
  SLCT LVR POSI : "D" position
With GST

Follow the procedure "With CONSULT-III".

Is "P1710 ATF TEMP SEN/CIRC" detected?

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".