LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2008 >> G37 Base >> Repair and Diagnosis >> Brakes >> Brakes Control Systems >> Brake Control System >> On-Vehicle Repair >> Abs Actuator And Electric Unit (Control Unit) >> Removal and Installation >> Removal

Removal and Installation: Removal

CAUTION:
  • Before servicing, disconnect the battery cable from negative terminal.
  • To remove brake tube, use a flare nut wrench to prevent flare nuts and brake tube from being damaged. To install, use flare nut crowfoot and torque wrench.
  • Do not apply excessive impact to ABS actuator and electric unit (control unit), such as dropping it.
  • Do not remove and install actuator by holding harness.
  • After work is completed, bleed air from brake tube. Refer to "BLEEDING BRAKE SYSTEM ".
  1. Remove cowl top cover. Refer to "EXPLODED VIEW ".
  2. Disconnect ABS actuator and electric unit (control unit) connector.
  3. Loosen brake tube flare nuts, then remove brake tubes from ABS actuator and electric unit (control unit).
  4. Remove tire (front LH side).
  5. Remove fender protector (rear): (front LH side). Refer to "FENDER PROTECTOR : EXPLODED VIEW ".
  6. Remove ABS actuator and electric unit (control unit) bracket mounting nut.
  7. Remove ABS actuator and electric unit (control unit) from vehicle.
scientia non olet · About LEMON Manuals