Repair Procedures: Installation

To install, reverse the removal procedure.

Perform the following procedures:

• Adjust a shift cable.
• Refill engine with engine oil.
• Refill a transaxle with fluid.
• Refill power steering fluid.
• Refill a radiator and a reservoir tank with engine coolant.
• Inspect for fuel leakage.
  • After assembling the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds and that the fuel line is pressurized.
  • Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.
  • Place a heater control knob on "HOT" position.
  • Bleed air from the cooling system.
  • Start engine and let it run until it warms up. (until the radiator fan operates 3 or 4 times.)
  • Turn Off the engine. Check the level in the radiator, add coolant if needed. This will allow trapped air to be removed from the cooling system.
  • Put radiator cap on tightly, then run the engine again and check for leaks.
• Clean the battery terminals, cable terminals by using sandpaper and assemble them, and apply grease to prevent a corrosion.