Rear Wheelhousing Trim Replacement: [Sedan]

NOTE:

Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not to bend or scratch the trim and panels.

Remove the rear seat.
(Refer to "REAR SEAT .
The rear center seat belt buckle (A) be removed after pushing the lock pin (B) as arrow direction.

Fig 1: Identifying Rear Center Seat Belt Buckle And Lock Pin
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the rear door scuff trim (A).

Fig 2: Identifying Rear Door Scuff Trim
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the rear pillar trim (A).

Fig 3: Identifying Rear Pillar Trim
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws and clips, then remove the luggage partition trim (A).

Fig 4: Identifying Luggage Partition Trim
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting blots, then remove the rear seat bracket (A).

Fig 5: Identifying Rear Seat Bracket
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting clip, then remove the rear wheelhousing trim (A).

Fig 6: Identifying Rear Wheelhousing Trim
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Replace any damaged clips.