DTC U3006-17 (VSA Control Unit)

DTC U3006-17  : Power Source Failure for ECU (High Voltage)

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC (VSA)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode.

   -4. Start the engine, then wait for 10 seconds or more.

   -5. Check for DTCs with the HDS.

   DTC Description	DTC
   U3006-17 Power Source Failure for ECU (High Voltage)

   Is DTC U3006-17 indicated?

   YES 

   The failure is duplicated. Go to step 2.

   NO 

   Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .

2. PGM-FI system DTCs check

   -1. Check for PGM-FI system DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC

   Are any DTCs indicated?

   YES 

   Go to indicated DTCs troubleshooting. After all PGM-FI system DTC's have been repaired, return to VSA and clear this code.

   NO 

   Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA modulator-control unit .