Removal and Installation

NOTE: 

• Where icon is shown for further information continue to the information below.
• Although a numbered sequence is shown, these "*1" indicated parts are separate components. If removal or replacement of one of the components is needed, it is not necessary to remove the other.

EGR Valve*1

	Torque: N.m (kgf.m, lbf.ft)
	Replace

2 

EGR Pipe A*1

	Torque: N.m (kgf.m, lbf.ft)
	Replace

EGR Pipe B*1

	Detailed information, notes and precautions
	Torque: N.m (kgf.m, lbf.ft)

Replace

EGR Valve 

1. Engine Cover - Remove
2. Engine Harness Holder - Lift
3. EGR Valve - Remove
4. All Removed Parts - Install

   1. Install the parts in the reverse order of removal.

EGR Pipe A 

1. Engine Cover - Remove
2. Splash Shield - Remove
3. EGR Pipe A - Remove
4. All Removed Parts - Install

   1. Install the parts in the reverse order of removal.

EGR Pipe B 

1. Engine Cover - Remove
2. EGR Pipe B - Remove
   Fig 4: EGR Pipe B Bolts And Nuts Tightening Squence

   Courtesy of HONDA, U.S.A., INC.

   Note for installation 

   • Set EGR pipe B to the intake manifold base and the intake manifold, and loosely tighten the bolts and nuts.
   • Tighten the bolts and nuts to specified torque in the numbered sequence shown.
3. All Removed Parts - Install

   1. Install the parts in the reverse order of removal.