DTC C0061-49, C0063-49
DTC C0061-49 : Acceleration Sensor Failure (Internal Circuit Failure)
DTC C0063-49 : Yaw Rate Sensor Failure (Internal Circuit Failure)
NOTE:
- Before you troubleshoot, review the general troubleshooting information .
- The yaw rate-acceleration sensor is built into the VSA modulator-control unit.
- Before troubleshooting, check the VSA modulator-control unit for proper mounting. If not properly installed the VSA modulator-control unit may set these codes.
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| C0061-49 Acceleration Sensor Failure (Internal Circuit Failure) | ||
| C0063-49 Yaw Rate Sensor Failure (Internal Circuit Failure) |
DTC (VSA)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
-4. Wait 5 seconds or more.
-5. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame C0061-49 Acceleration Sensor Failure (Internal Circuit Failure) C0063-49 Yaw Rate Sensor Failure (Internal Circuit Failure) Is DTC C0061-49 or C0063-49 indicated?
YES
Check for loose terminals and poor connections in the VSA modulator-control unit 38P connector. If they are OK, replace the VSA modulator-control unit .
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.