VSA Cannot Be Turned OFF
- Turn the ignition switch to LOCK (0).
- Check the VSA OFF switch (see VSA OFF SWITCH TEST
).
Is the VSA OFF switch OK?
YES - Go to step 4.
NO - Replace the VSA OFF switch (see VSA OFF SWITCH TEST ).
- Disconnect the VSA OFF switch 5P connector.
- Disconnect the gauge control module 32P connector (see step 3 on GAUGE CONTROL MODULE REPLACEMENT ).
- Check for continuity between gauge control module 32P connector terminal No. 21 and VSA OFF switch 5P connector terminal No. 2.Fig 1: Checking For Continuity Between Gauge Control Module 32P Connector Terminals And VSA OFF Switch 5P Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES - Go to step 6
NO - Repair an open in the wire between the gauge control module and the VSA OFF switch.
- Check for continuity between VSA OFF switch 5P connector terminal No. 2 and body ground.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES - Repair short to body ground between the gauge control module and the VSA OFF switch.
NO - Go to step 7
- Check for continuity between VSA OFF switch 5P connector terminal No. 1 and body ground.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES - Substitute a known-good gauge control module and recheck. If it is OK, replace the original gauge control module (see GAUGE CONTROL MODULE REPLACEMENT ).
NO - Repair an open in the wire between the VSA OFF switch and body ground (G501).