Power Mirror Replacement

Remove these items:
- Door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION )
- Plastic cover, as needed (see step 3 on FRONT DOOR PANEL REMOVAL/INSTALLATION )
Raise the door glass fully.
Disconnect the connector (A).

Fig 1: Disconnecting Power Mirror Connector
Detach the harness clip (B).
Remove the maintenance cap (A), and remove the nuts. While holding the mirror, detach the clip (B), then remove the mirror (C). Take care not to scratch the door.

Fig 2: Identifying Maintenance Cap, Harness Clip And Power Mirror
Install the mirror in the reverse order of removal, and note these items:
- Make sure the connector is plugged in properly.
- When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.