Repair Procedures: Replacement

Remove the rear door window glass.
(Refer to "REAR DOOR WINDOW GLASS ")
Remove the rear door outside handle.
(Refer to "REAR DOOR OUTSIDE HANDLE ")
Loosen the rear door outside handle base mounting bolt (A).
Tightening torque:

2.0 - 2.9 N.m (0.2 - 0.3 kgf.m, 1.4 - 2.2 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the rear door main wiring connector (A).

Courtesy of HYUNDAI MOTOR AMERICA
Loosen the rear door latch mounting screws.
Tightening torque:

6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.0 - 8.0 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting bolts, remove the rear door module (A).
Tightening torque:

7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors and rear door module wiring harness (A).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the rear door latch assembly.
(Refer to "REAR DOOR LATCH ")
Remove the rear speaker.
(Refer to Body Electrical System - "SPEAKERS ")
Remove the rear power window motor.
(Refer to Body Electrical System - "POWER WINDOW MOTOR ")
To install, reverse the removal procedure.
Information
- Make sure connectors are connected properly and each rod is connected securely.
- Make sure the door locks/unlocks and opens/closes properly.