Fuel System Pressure Check

Special Tool(s) / General Equipment 

Courtesy of FORD MOTOR COMPANY	310-D009 (D95L-7211-A) Fuel Pressure Test Kit

Check 

1. 1.
   
   Release the fuel system pressure. REFER to: Fuel System Pressure Release .

1. 2.
   
   Disconnect the battery ground cable. REFER to: Battery Disconnect and Connect .

1. 3.
   
   Disconnect the fuel tube-to-fuel jumper tube quick connect coupling. REFER to: Quick Release Coupling .

Courtesy of FORD MOTOR COMPANY

1. 4.
   
   Install the Fuel Pressure Test Adapter and the Fuel Pressure Test Kit between the fuel tube and the fuel jumper tube.

   Use Special Service Tool: 310-D009 (D95L-7211-A) Fuel Pressure Test Kit.

Courtesy of FORD MOTOR COMPANY

1. 5.
   
   
   NOTE: The fuel pump control module electrical connector was previously disconnected to release the fuel system pressure and must be reconnected to test the fuel system pressure.

   Reconnect the fuel pump control module electrical connector.

1. 6.
   
   Reconnect the battery ground cable. REFER to: Battery Disconnect and Connect .

1. 7.
   
   
   NOTE: Carry out a Key ON Engine OFF (KOEO) visual inspection for fuel leaks prior to completing the fuel system pressure test.
   NOTE: After completion of the fuel system pressure test, open the drain valve on the Fuel Pressure Test Kit and release any residual fuel into a suitable container prior to removing the tool.

   Test the fuel system pressure to make sure it is within the specified range. REFER to: Specifications .