Seat Backrest Thermo-Electric Device: Installation
- 1.
Install the backrest TED.
- 1.
Position the TED through the power lumbar cable.
- 2.
Attach the TED to the backrest foam pad wire.
- 3.
Engage the TED upper retainers to the backrest frame wire.
- 4.
Connect the electrical connector and attach the pin-type retainer.
- 2.
Roll the backrest cover down, attach the hook-and-loop strips and engage the J-clip at the rear to the backrest frame wire.
- 3.
Roll the backrest cover down, attach the hook-and-loop strips and install the 3 second row hog rings.
- 4.
Roll the backrest cover down, attach the hook-and-loop strips and install the 3 first row hog rings.
- 5.
Roll the backrest cover down and attach the hook-and-loop strips.
- 6.
Route the wire harness(es) and air hoses (if equipped) through the hole(s) in the backrest cover and engage the lower J-clips.
- 7.
On each side, wrap the backrest cover around the recliner and attach the hook-and-loop strips and clip.
- 8.
Install the seat backrest. For additional information, refer to Seat Backrest - Front .