LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> Focus S, Standard Trans, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (MULTIFUNCTION Electronic Modules -- (Electric)) >> Removal and Installation >> Body Control Module (BCM) >> Removal

Body Control Module (BCM): Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.
  1. WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in GENERAL INFORMATION . Failure to follow this instruction may result in serious personal injury.

    Refer to: HEALTH AND SAFETY PRECAUTIONS .

  2. NOTE: If installing a new BCM  , verify at least 2 of the vehicle keys are available prior to carrying out this procedure.
    NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new module after installation.

    Upload the module configuration information from the BCM  into the scan tool by following the scan tool on screen instructions. For additional information,

    Refer to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION .

  3. Remove the 2 instrument panel insulator retainers and the instrument panel insulator.
    G08065306
  4. Release the 3 RH  instrument panel side trim panel clips and remove the side trim panel.
    G08065305
  5. G08065307
  6. Remove the BCM  .
  7. G08100203
scientia non olet · About LEMON Manuals