Section 2 (Manual Transmission (MTX75)): Specifications
WARNING: This page is about a different variant/trim than selected.
CAPACITIES
| Liters | |
|---|---|
| Transmission fluid (0- 5 mm below the lower edge of the inspection hole) | 1.9 |
TRANSMISSION RATIOS
| 2.0L engine | |
|---|---|
| 1st gear | 3.667 |
| 2nd gear | 2.136 |
| 3rd gear | 1.448 |
| 4th gear | 1.028 |
| 5th gear | 0.805 |
| Reverse gear | 3.727 |
| Final drive | 3.824 |
SHIM THICKNESS REQUIRED
| Description | Input shaft | Output shaft | Differential assembly |
|---|---|---|---|
| Measuring shims (mm) | 1.00 | 1.00 | 1.10 |
| Measured end float (example) (mm) | + 0.22 | + 0.32 | + 0.36 |
| Preload figure (mm) | - | + 0.13 | + 0.33 |
| End float (mm) | - 0.07 | - | - |
| Required shim thickness (example) (mm) | = 1.15 | = 1.45 | = 1.79 |
| Shims available (mm) | 1.15 - 1.71 (in steps of 0.01 mm) | 1.31 - 1.91 (in steps of 0, 02 mm) | 1.40 - 2.20 (in steps of 0.05 mm) |