Torca(R) Clamp

Torca(R) Clamp

1. Remove the nut from the Torca(R) clamp.

2. Grind the spot weld from the Torca(R) clamp and remove the clamp.

3. Clean the uneven surface area and, using an abrasive pad, clean the Torca(R) clamp surface area of any rust on the pipe.

4. Position a new Torca(R) clamp 0-3 mm (0-0.12 in) from the button slot.





5. Rotate the Torca(R) clamp until it is 83 to 93 degrees from the slot in the side of the pipe.