LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Taurus Limited, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 888 (Electronic Engine Control System) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor - 2.3L >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Pull back the cylinder head temperature (CHT) sensor cover and disconnect the electrical connector.
  3. Remove the CHT sensor.
    • To install, tighten to 12 Nm (9 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals