LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2010 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Traction Control >> Anti-Lock Brake System - Vehicle Dynamic Systems >> Removal And Installation >> Wheel Speed Sensor Ring - Rear >> Installation

Wheel Speed Sensor Ring - Rear: Installation

  1. Using the Axle Bearing/Seal Plate and the Wheel Speed Sensor Ring Installer, align the rear anti-lock brake sensor indicator to the rear axle shaft.
    Fig 1: Identifying Special Tools (205-090 And 206-041)
    G06403288Courtesy of FORD MOTOR CO.
  2. Using the Axle Bearing/Seal Plate and the Wheel Speed Sensor Ring Installer, press the rear anti-lock brake sensor on the rear axle shaft to specification.
    Fig 2: Identifying Special Tools (206-041 And 205-090)
    G06403289Courtesy of FORD MOTOR CO.
  3. Install the rear axle shaft. For additional information, refer to REAR DRIVE AXLE/DIFFERENTIAL - FORD 7.5-INCH RING GEAR .
scientia non olet · About LEMON Manuals