LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2008 >> Explorer 4.6 8, RWD >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Removal And Installation >> Power Steering Pump - 4.0L >> Installation

Power Steering Pump - 4.0L: Installation

    NOTE: A new Teflon® seal must be installed.
  1. Using the special tool, install a new Teflon® seal to the pressure line fitting.
    2. Fig 1: Installing Teflon(R) Seal Using Special Tool 211-D027
    G03950191Courtesy of FORD MOTOR CO.
  2. Position the power steering pump and install the 3 bolts.
    • Tighten to 25 Nm (18 lb-ft).
  3. Connect the pressure line-to-pump fitting.
    • Tighten to 65 Nm (48 lb-ft).
  4. Connect the power steering pump supply hose.
  5. Install the power steering pump supply hose bracket bolt.
    • Tighten to 11 Nm (8 lb-ft).
  6. Install the pressure line bracket-to-engine bolt.
    • Tighten to 11 Nm (8 lb-ft).
  7. Install the power steering pump pulley. For additional information, refer to Power Steering Pump Pulley - 4.0L .
  8. Fill the power steering system. For additional information, refer to STEERING SYSTEM - GENERAL INFORMATION article.
scientia non olet · About LEMON Manuals