LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Explorer 4.0 E, RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Handles, Locks, Latches And Entry Systems >> General Procedures >> Auto Lock and Horn Chirp Programming >> Auto Lock Programming Using the Ignition Lock Cylinder

Auto Lock Programming Using the Ignition Lock Cylinder

  1. Close all doors and windows.
  2. Confirm that the ignition key is OFF.
    3. NOTE: Steps 5 through 9 must be carried out within 30 seconds.
  3. Turn the ignition key from OFF to RUN.
  4. Press the door lock control switch UNLOCK button 3 times.
  5. Turn the ignition key from RUN to OFF.
  6. Press the door lock control switch UNLOCK button 3 times.
  7. Turn the ignition key from OFF to RUN.
  8. Verify the horn chirps. This indicates the enable/disable mode and now is ready to accept program changes.
  9. Press the door lock control switch UNLOCK button then the LOCK button 1 time to command the module to toggle the auto lock/relock feature.
  10. Verify that the horn chirps. There should be 1 chirp indicating that auto lock/relock feature has been disabled. If 1 chirp is heard, followed by a longer sound of the horn, the auto lock/relock feature has just been enabled.
  11. Turn the key to the OFF position or wait 2 minutes to exit the enable/disable mode.
  12. Verify that the horn chirps once to indicate that a feature has been changed and that auto lock/relock has been toggled.
scientia non olet · About LEMON Manuals