LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2004 >> Mustang Mach 1, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Clutch System) >> Removal And Installation >> Flywheel Ring Gear >> Removal

Flywheel Ring Gear: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the flywheel. For additional information, refer to ENGINE- 3.8L & 3.9L , ENGINE- 4.6L (2V) or ENGINE- COBRA 4.6L (4V) .
    2. WARNING: This procedure should be carried out only by a correctly equipped and experienced acetylene torch operator. Tongs must be used or asbestos gloves worn when handling the heated flywheel ring gear. Failure to follow these instructions can result in personal injury.
    CAUTION: Tap the flywheel ring gear evenly to prevent binding.
  2. Remove the flywheel ring gear from the flywheel.
    • Evenly heat the flywheel ring gear with an acetylene torch and use a brass drift to drive the flywheel ring gear off the flywheel.
scientia non olet · About LEMON Manuals