Before Pinpoint Tests

Before Pinpoint Tests

NOTE: Prior to entering pinpoint tests, cheek the Powertrain Control Module (PCM) wiring harness for correct connections, bent or broken pins, clone loose wires, correct routine, correct seals and their condition. Check the PA sensors and actuators for damage.

NOTE: If a concern still exists after electrical diagnosis has been carried out, refer to Diagnosis By Symptom. 4R100

If DTCs appear while carrying out the on-board diagnostics, refer to the Diagnostic Trouble Code Chart for the appropriate procedure. Prior to entering pinpoint tests, refer to any TSBs for transmission concerns. Trouble Code to Pinpoint Test Charts