Servo Linkage: 2.2L
Loosen lock nut and adjusting nut. Pull on cable housing without moving servo rod. Turn adjusting nut "A" until there is .039-.118" (1-3 mm) of clearance between nut "A" and servo bracket. Tighten lock nut. See Figure .
Loosen lock nut and adjusting nut. Pull on cable housing without moving servo rod. Turn adjusting nut "A" until there is .039-.118" (1-3 mm) of clearance between nut "A" and servo bracket. Tighten lock nut. See Figure .