Clutch/Starter Interlock Switch
- Disconnect wiring connector at switch by flexing retaining tab. Test electrical continuity of switch with a test light or ohmmeter. Switch should be open (infinity) when pedal is up and clutch is engaged. Switch should be closed (zero ohms) when clutch pedal is pressed to floor.
- If switch does not operate properly, check position of self-adjusting clip. See Fig 1
. Adjust switch by removing both halves of clip and position clip closer to switch body. Reset switch by depressing clutch pedal to floor. If switch still does not operate properly, replace switch.
Courtesy of FORD MOTOR CO.