LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1992 >> Summit Base, 2D Hatchback, Standard >> Repair and Diagnosis (Single Page) >> Steering >> Power Steering >> Steering System - Power >> Lubrication >> Hydraulic System Bleeding >> 4WS (Rear System)

4WS (Rear System)

  1. Bleed air from power steering system. See ALL MODELS. Have an assistant enter vehicle. Raise and support vehicle. Start engine, and let it idle. Loosen bleed screw on left side of rear control valve, and install a bleed hose to bleed screw.
  2. Have assistant turn steering wheel to full left position, and then immediately return wheel half way. Ensure air and fluid is discharged from hose. Repeat step several times. Ensure all air has been bled from system. Repeat step for right side bleed screw, turning steering wheel to full right position, and then immediately returning wheel half way.
  3. Turn engine off. Loosen bleed screws on power cylinder. Install a bleed hose to power cylinder bleed screws. Have assistant start engine and run vehicle to 43-50 MPH to circulate fluid. Lower vehicle speed to 19-25 MPH, and maintain speed while turning steering wheel to full left and right positions.
  4. When steering wheel is turned to full left or right positions, pressure will rise and air will circulate through bleed hose. Ensure air is discharged into oil reservoir. Repeat step several times until all air has been bled from system.
scientia non olet · About LEMON Manuals