Coil, Ignition: Removal: 3.6L

Disconnect and isolate the negative battery cable.

Fig 1: Engine Cover
Courtesy of CHRYSLER GROUP, LLC
Remove the engine cover (1).

Fig 2: Inlet Air Temperature (IAT) Sensor Electrical Connector, Air Inlet Hose Assembly & Fasteners
Courtesy of CHRYSLER GROUP, LLC
If removing the ignition coils from cylinders 1, 3 or 5 on the right side of the engine, first remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL .

Fig 3: Upper Intake Manifold & Bolts
Courtesy of CHRYSLER GROUP, LLC
If removing the ignition coils from cylinders 2, 4 or 6 on the left side of the engine, first remove the upper intake manifold (2) and insulator. Refer to MANIFOLD, INTAKE, REMOVAL .

Fig 4: Electrical Connector, Ignition Coils & Ignition Coil Retaining Bolts
Courtesy of CHRYSLER GROUP, LLC

NOTE:
The left side ignition coils are shown in the illustration, the right side ignition coils are similar.
Unlock and disconnect the wire harness connector (1) from the ignition coil.
Remove bolt (3) and pull the ignition coil (2) from cylinder head cover opening with a slight twisting action.